Ruskin AIRFLOW-IQ User Manual

Ruskin AIRFLOW-IQ

24 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

1

Airﬂow-IQ Start-up & Commissioning Guide

Air Quality Solutions

Start-up & Commissioning Guide

Model: AIRFLOW-IQ

Electronic Air Measuring Station with BACnet

Actuator and Class 1A Damper

ALL STATED SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE OR OBLIGATION

II-AIRFLOW-IQ 718/Replaces II-AIRFLOW-IQ 418 ©Ruskin July 2018

Table of Contents

Questions and Answers:

S
Shannon HurleyJul 31, 2025
What to do if Ruskin Measuring Instruments airflow readings don't match T&B reports?
- K
  Kyle JohnsonJul 31, 2025
  If the airflow readings from your Ruskin Measuring Instruments do not match the reports from T&B, it could be due to turbulent airflow or air flowing in two directions through the plane of the air measurement station. Try using Automatic K factor Configuration and use 1 point calibration if only gain is required. If the flow is non-linear, use the two or three-point calibration feature. You may need to install additional probes to provide more sensing points.

Ruskin AIRFLOW-IQ Specifications

General

Category	Measuring Instruments
Accuracy	±3% of reading or ±0.2 m/s, whichever is greater
Power Supply	24 VDC or 230 VAC
Type	Airflow Measurement Device
Temperature Range	0 to 50°C
Output Signal	4-20 mA or 0-10 V
Resolution	0.1 m/s
Operating Temperature	0 to 50°C
Operating Humidity	0 to 95% RH non-condensing
Display	LCD

Summary

APPLICATIONS

SAFETY WARNINGS AND IMPORTANT NOTES

UNPACKING AND INSTALLATION

MINIMUM MOUNTING DISTANCES

ACTUATOR CONTROLLER OPERATION

ANALOG INPUTS

Information on analog input signals for airflow measurement and control.

BACNET CONTROL

Explanation of BACnet setpoint configuration and data points for control.

ACTUATOR FEATURES AND COMMISSIONING

MODE OF OPERATION

How the actuator functions as a BACnet interface for air measurement.

FEATURES

Key features of the actuator including web server, BACnet, and fail-safe interlock.

COMMISSIONING

Steps for site-specific network and station configuration by the installing contractor.

WIRING

Pin assignments for the 3-ft plenum cable connector and field power wiring.

LOG ON TO ACTUATOR WEB INTERFACE

ACTUATOR WEB INTERFACE OVERVIEW

RUSKIN AMS OBJECT LIST

ACTUATOR PRODUCT DESCRIPTION

WIRING GUIDELINES

PRIMARY PROBE WIRING

DAMPER OPERATION & MAINTENANCE

MAINTENANCE

Procedures for cleaning, lubricating, and inspecting damper components.

OPERATION

How to operate the damper through a full cycle and check linkage.

TDP05K MENU STRUCTURE

OPERATOR MENU

FLOW CONFIGURATION

ANALOG OUTPUT CALIBRATION

K-FACTOR CONFIGURATION

BACNET CONFIGURATION

Settings for enabling BACnet communication, instance, address, and baud rate.

BACNET FLOW ALARM CONFIGURATION

BACNET TEMPERATURE ALARM CONFIGURATION

TROUBLESHOOTING

REPAIR INFORMATION

PROBE MAINTENANCE

TECHNICAL SPECIFICATIONS