6
SHOT OF STEAM
1. Steam is available when the temperature control is at
S
or above.
2. Lift the iron off the fabric.
3. Press the ~ button.
4. Leave 4 seconds between shots, to let the temperature build up.
DRY IRONING
1. Set the steam control to
S
.
2. Wait until the light goes off then start ironing.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
• Check that there’s adequate ventilation behind the fabric, otherwise moisture
may build up, causing mildew.
• Check that there’s nothing behind the fabric that may be damaged by the
steam.
• Check that pockets, turn-ups, and cuffs are empty.
• Check that there’s water in the reservoir.
1. Set the temperature control to max set the steam control to #.
2. Hold the iron close to (but not touching) the fabric.
3. Press the ~ button (you’re using the “shot of steam” function vertically).
4. Leave 4 seconds between shots, to let the temperature build up.
AUTO SHUT-OFF
If the iron is motionless, it will switch off after about 30 seconds lying down, or about
8 minutes if it’s upright.
The iron will beep and the light will flash continuously until you move the iron.
To switch on again, lift it up, tilt it forward, then sit it upright to return to operating
temperature. No settings are lost during auto shut-off.
AFTER USE
1. Set the temperature control to • set the steam control to
S
.
2. Unplug the iron.
3. Raise the side of the water inlet cover to open it.
4. Hold the iron over a sink, turn it upside down, and drain the water from the
reservoir.
5. Sit the iron on its heel, and leave it to cool down completely.
6. When cold, wipe off any moisture, and close the water inlet cover.
To Next Page
Loading...
