RINSE AFTER DE-SCALING
• Fill the kettle with fresh cold water to the MAX level mark on the water gauge.
• Select the 100°C button and allow the kettle to boil.
• Discard the water into the sink.
• Repeat the rinsing process as required, discarding the water in the kettle each time.
NOTE: Products returned under warranty with faults due to scale may be subject
to a repair charge.
WATER FILTER
Scale particles suspended in the water may give it a cloudy or greasy appearance. The
filter will prevent these particles going into your drink. Remove and clean the filter regularly.
CLEANING THE FILTER
• Check your hands are free from soap, hand cream, or anything which might leave a
taint.
• Remove the plug from the wall power outlet.
• Allow the kettle to cool down fully.
• Push the lid release button.
• Using the tab at the top of the lter pull the lter up and out of its housing.
NOTE: Take care not to press on the mesh part of the filter – you may damage it.
• Rinse the lter under a running tap whilst brushing with a soft brush.
• Rinse the kettle in case scale particles have fallen inside.
• Turn the lter so the tab at the top of the lter faces the rear of the kettle.
• Slide it down into the triangular lter housing guide so the clip is in place. Push the
tab into place and ensure this is in place.
• Rell the kettle and close the lid.
Caution: Do not use the kettle without the filter in place – it may eject boiling
water.
To Next Page
Loading...
Need help?
General
