15
Installation
Ducted air exhaust system
• When installing the ducted version, connect the hood to the chimney using
either a flexible or rigid pipe ɸ 150 mm or ɸ 120 mm. The product is supplied
with a ɸ 150 mm flexible pipe therefore to install a ɸ 120 mm air exhaust
connection a reducer flange (not supplied) will need to be attached to the
outlet on the hood.
• Fix the ɸ 150 mm flexible pipe in position using sufficient pipe clamps (not
supplied).
Note: Align the flue duct before tightening the screws.
The has to be a 2 degree decline in the exhaust pipe to the outside vent
To Next Page
Loading...
