Installation
• The unit should be kept away from direct sunlight.
• Remove all transport tapes and foam protection pieces. Clean the
interior of the appliance with a cloth dampened in lukewarm soap and
water. Wipe with clear water and wipe dry.
• When the appliance has been positioned, adjust the two front feet to
ensure the unit is stable. This is essential to ensure quiet running and
proper door opening /closing. See figure below.
• Plug in the cooler and adjust the temperature to the required level by
the temperature adjustment buttons. Close the door.
• Leave the appliance for a minimum of 3 hours for the correct
temperature to be reached before placing bottles inside.
10
To Next Page
Loading...
Need help?
General
