WARNING: Electrical Shock Hazard.
Note: Before cleaning, ensure the control is set to the ‘0’
Position (OFF) and remove the plug from the wall socket.
Note: Do not allow the controller to come in contact with any
wet solution.
Before you clean the appliance, disconnect the mains plug from
the wall socket.
Detach the control
• Lift the tab on the controller attached to the plastic
connector on the blanket, carefully pull the plug connector
away from the blanket. The controller MUST never be
immersed in water.
• The heating wires within the electric blanket are fully water-
proof.
• Roll up each of the tie tapes before cleaning or storing and
secure them to avoid tangling.
CLEANING AND CARE
Page 11
Disconnect
before
cleaning
To Next Page
Loading...
