Russell Hobbs RHMA 050

7
from the ON time until 24:00. The flashing bar on the time scale indicates the real time and
moves a segment ahead every 30 minutes. The unit will operate daily according to the timer
setting.
RepeatedONandOFF
ProgrammingthetimerforrepeatONandOFF-whentheunitisNOTRUNNING.
• Perform the standard steps as described above.
• Repeat the above procedure while the digits are still flashing for setting the OFF.
The linear time scale will be OFF between 00:00 to the time set with the timer to ON and
from the OFF time until 24:00. The flashing bar on the time scale indicates the real time
and moves a segment ahead every 30 minutes. The unit will operate daily according to the
timer setting.
After a power failure, or after the unit has been unplugged, you will have to program the
timer settings again.
Cancellingthetimerfunction
In order to cancel the timer programming press the -button momentarily, then it will
return to the time display. The daily mode will be cancelled as well. The black segments in
the linear time scale will disappear.
LCDbluebacklight
In order to switch off the blue back light, press the and buttons at the same time. The
blue back light will blink twice and goes off after three seconds.
By pushing any of the buttons the blue back light will come on again.
Airflow
On the moment the air conditioner is connected to the mains, the louvres open and close
and stay closed.
• When the ON-button is pressed, the louvres open to maximum and return to an angle of
75° above the upper plane of the louvres housing.
• Press the -button, the louvres will swing continuously up and down between 30° and
80° above the upper plane of the louvres housing.
• By pressing the -button again the movement will stop and the louvres remain in that
position. The direction of the air flow is then constant.
• When the OFF-button is pressed, the louvres close.
This way of directing the air flow is particularly convenient when using the remote control: a
user friendly approach to your comfort.
In order to direct the air flow to a lower angle, raise the louvres housing by pulling it up only
by the centre of its back rim.
Air outlet up, louvres
opened
Air outlet down, louvres
closed
Raising the louvres
housing.