Russell Hobbs RHPAC4002

TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The appliance does not
come on
-
There is no current
-
It is not plugged into the
mains
-
The internal safety device
has tripped
-
Wait
-
Plug it into the mains
-Wait 30 minutes and if the
problem persists please
contact our Customer
Service team on
0345 209
7461.
The appliance works for a
short time only
-
There are bends in the air
exhaust hose
-
Something is preventing
the air from being
discharged
-
Position the air exhaust
correctly, keeping it as short
and free of curves as
possible.
-
Check and remove and
obstacles obstructing the air
discharge.
The appliance works but
does not cool the room
-
Windows, doors and/or
curtains are open
-
There are heat sources in
the room (oven, hairdryer
etc.)
-
The air exhaust hose is
detached from the
appliance
-
The technical specification
of the appliance is not
adequate for the room in
which it is located
-
Close doors, windows and
curtains, bearing in mind the
“tips for correct use” given
above
-
Remove the heat sources
-
Fit the air exhaust in the
housing at the back of the
appliance
During operation, there is
an unpleasant smell in the
room
-
The air filter in clogged
-
Clean the filter as
described earlier within this
instruction booklet
The appliance does not
operate for about three
minutes after restarting it
-
The internal compressor
safety device prevents the
appliance from being
restarted until three
minutes have elapsed since
it was last turned off
-
Wait, this delay is part of
the normal operation of the
appliance
The following message
appears on the display:
LT/PF/FT
-
The appliance has a self-
diagnosis system to identify
a number of malfunctions
-
See the SELF-DIAGNOSIS
section of this booklet
RHPAC4002 v2.4 27