Russell Hobbs RHSM1001

9
STEAM MOP ASSEMBLY
Microfibre mop pad attachment
The steam mop should never be operated
without the mop pad attached.
To attach the pad, place it on the floor with the
velcro facing upwards and removal lip to the
back. Lift the mop above the pad and align the
head with the mop pad. Lower the pad and rest
the mop on it to secure the velcro to the head.
To remove the pad, secure your foot on the
protruding piece of cloth and lift the mop away.
Carpet glider attachment
The mop can be used with the carpet glider
attachment to refresh carpets and rugs.
To attach the carpet glider, lift the mop over the
glider and lower the front of the mop head
under the two plastic ribs. Next, lower the back
end of the head. This should secure the head in
place.
To remove the glider, place your foot on the
protruding plastic and lift the mop upwards.