Venting mode
Extraction-air mode Circulation-air mode
Dependent on the venting mode that is required you may need to change the
position of the venting mode level that is situated inside the hoods next to the fan.
The lever is held in place with a screw, this will need to be removed before moving
the lever and then replaced.
Extraction-air mode: To vent the air outside turn the venting lever to the left.
Circulation-air mode: To recirculate the air turn the venting lever the right.
If you choose extraction-air mode, install check valve on the vent hole.
10
Extraction-air mode
Circulation-air mode
To Next Page
Loading...
