4
IMPORTANT INFORMATION
• For best performance, we recommend using distilled, purified or filtered water in your
steamer. Tap water contains minerals that can build up inside your steamer over time and
reduce its efficiency or even cause damage.
• Never use perfumes, oils or other additives.
• Always check the garment’s care label before steaming, and always test fabrics for
colourfastness in an inconspicuous area. Steamers are not recommended for use on leather,
suede, vinyl, plastic, or other materials that are sensitive to steam.
• During use the steamer and accessories will become HOT. Never try to fit or remove
attachments while still hot.
• After preheating, prime the water pump by holding the steam trigger until steam forms.
• It is normal to feel or hear the water pump inside the device. It may become louder when the
water level in the tank is low. Check and refill the tank when required.
• Small amounts of dripping might occur during use. If excessive, your steamer needs time to
get back up to full temperature. Just allow the steamer a minute to reheat.
• Wearing clothes immediately after ironing or steaming can actually create wrinkles. Always
allow the clothing to cool for about 5 minutes before wearing.
ATTACHMENTS
Your steamer has four attachments. Each attachment is marked with an icon.
Fabric attachment
Opens up the fibres in fabrics so the steam
can better penetrate the material; good for
thicker materials like coats and can also
help to remove pilling.
Delicate fabric attachment
Reduces the possibility of damage to
fabrics such as silk and lace.
Tip: For items with printing/embellishment,
turn the garment inside out to avoid
damage to sensitive areas.
Upholstery attachment
Deodorise, refresh and clean larger
materials such as bedding, mattresses,
curtains, soft toys, sofas and much more.
Always test for colourfastness and heat
sensitivity on an inconspicuous area.
Lint attachment
For any garment that allows medium to
high heat and allows for use of steam.
Tip: Attachment helps remove lint, hair and
animal fur.
FITTING/REMOVING (FIG. A)
1. Make sure that the steamer and attachment are cool.
2. Hook the top of the attachment over the top edge of the
steamer.
3. Click the bottom edge into place.
4. Remove attachments by lifting them away from your
steamer starting at the heel. When removing the attachment, watch out for condensation
that may have built up during use.
CLICK!
h
A
To Next Page
Loading...
