Need help?Do you have a question about the Russound ST2 Smart Tuner and is the answer not in the manual?
General| Output Level | 2V RMS |
|---|---|
| Tuner Type | FM Tuner |
| Streaming Services | vTuner |
| Audio Formats | MP3, WMA, AAC, FLAC, WAV |
| Connectivity | Wi-Fi, Ethernet, USB |
| Audio Outputs | Analog (RCA) |
| Control | Web Browser Interface |
| Presets | 30 FM Presets |
| Frequency Range | FM: 87.5 MHz - 108 MHz |
| Signal-to-Noise Ratio | >90 dB |
| Power Supply | 12V DC |
| Power Consumption | 5W |
| Total Harmonic Distortion | <0.05% (Analog Output) |
General safety guidelines for operating the appliance.
Key operational precautions for safe and correct usage.
Diagram showing ST2 Tuner connection with a CAV6.6 controller.
How to control tuner functions via UNO-S2 keypad through CAV6.6.
How to control tuner functions via UNO-LRC1 remote through CAV6.6.
Setting source numbers, updating firmware, and chassis setup.
Minimum setup needed for ST2 to be controlled by CAV6.6.
Step-by-step guide to update the ST2 tuner's operating system firmware.
Procedure to reset the ST2 tuner to its original factory default settings.
Detailed steps to configure the CAV6.6 for ST2 Tuner control.
How the ST2 acts as a peripheral via RNET bus for CAV6.6.
To Next Page