RUSTA 31901056 - Grass Trimmer Settings; Support Handle Adjustment; Telescopic Shaft Length Adjustment; Cutting Angle Adjustment

ENG
GRASS TRIMMER SETTINGS
ADJUSTING THE SUPPORT HANDLE
• The support handle can be set in
dierent positions. Adjust the handle so
the trimmer disc slopes slightly forwards
when you are in the working position.
• Loosen the bolt on the support handle and
adjust the handle to the desired position.
• Tighten the bolt.
ADJUSTING THE LENGTH OF
TELESCOPIC SHAFT
• The length of the telescopic shaft can
be adjusted in line with your own height.
• Loosen the threaded lock casing.
• Adjust the telescopic shaft to the
desired length and then tighten the
threaded lock casing
ADJUSTING THE CUTTING ANGLE
• By adjusting the cutting angle,
you can cut the grass in dicult
to reach places, such as under
branches or close to the sides
of buildings.
• Tread on the pedal on the
motor housing and angle the
telescopic shaft. There are four
pre-set angles.
0o
Telescopic
shaft
Pedal
30o
60o
90o
Threaded
lock casing
Telescopic
shaft
Support
handle
Bolt
12