VERTICAL CUTTING / EDGE CUTTING
Pay articular care and attention when holding the trimmer disc vertically.
Avoid personal injury by maintaining a safe distance from the trimmer head.
When cutting vertically
• Move the trimmer to the left and right in slow swaying
movements when you cut slopes.
• Set the handle bar at 180° (see page 13).
• Set the cutting angle to at 0° (see page 12).
• Push the plant protector spacer into the up position.
When edge cutting
• Move the grass trimmer slowly along
• Set the handle bar at 90° (see page 13).
• Set the cutting angle to at 90° (see page 12).
• Push the plant protector spacer into
the up position.
CLEANING AND MAINTENANCE
• Contact a service centre if you cannot repair the trimmer as described in
the user instructions. Avoid risk of personal injury – always use original spare parts.
• Switch o the grass trimmer and remove the battery before doing any maintenance work.
• To extend the working life of the grass trimmer, the following cleaning and
maintenance work should be done regularly.
CLEANING
• Do not spray the grass trimmer with water. Do not immerse the grass trimmer in
water. Risk of electric shock.
• Keep the ventilation holes unblocked and the motor housing and handles clean. Clean
these parts with a damp cloth or brush. Do not use solvent when cleaning the trimmer,
you could cause permanent damage.
• After each use: Remove any grass and dirt from the safety guard and trimmer head.
• Clean the trimmer head: Remove the trimmer blade and scrape any dirt o the
mounting that the trimmer blade sits on.
ENG
Vertical cutting
Edge cutting
14
To Next Page
Loading...