ASSEMBLY INSTRUCTIONS
USE
1. Screw the inlet (8) and pump (1)
together by turning clockwise.
Check that the connection is tight
to avoid leakage.
2. Place the O-ring (10) in the outlet
(9).
3. Screw the outlet (9) and shower
head (11) together by turning
clockwise.
1. To start, press the switch (2).
4. Take the pump out of the water to turn it o.3. Place the shower head (11) in the holder (12) to
attach it to the hook or suction cup, or hold the
shower head in your hand.
2. Place the pump (1) in water. Note! Important! The
pump must be fully immersed in the water as long
as it is running.
NOTE! Fully charge the product before using it for the first time • Do not leave the product unattended
while it is running • Always remove the product from the water and turn it o when not in use • Always
check that the product is intact before using it.
5
To Next Page
Loading...