Rustibus 2000 Electric Low - Page 14

REPLACING THE CHAIN DRUM
REPLACING THE DISPOSABLE CHAIN DRUM
Information guide on how to replace the Chain Drum.
Genuine Rustibus® parts only! Machine may vary from pictures
1.Replacing the Chain Drum on
Rustibus® 2000 Series is the same
for all types : low, standard, electric,
pneumatic and our Atex/Ex Certied
machines.
3. Make sure that the square
bearing is on the inside and the
round bearing is on the outside.
2. Make sure that the grease nipple (*g.1) is poiting down when you are
putting the chain drum inside the chassis.
4. Put on the bolts but don´t fasten
them more then necessary.
5. Go on the other side of the chassis
and make sure the round bearing is
on the correct spot.
*g.1
*g.1