Need help?Do you have a question about the Rvision RCR3910 and is the answer not in the manual?
Remove and inspect all packaging material before powering on the refrigerator.
Ensure proper air circulation by following recommended clearances around the refrigerator.
Use a suitable, grounded 115-volt, 15-amp outlet and avoid adapters.
Use only a 3-wire grounding extension cord rated equal to or greater than the appliance.
Avoid uninsulated/unheated locations and ensure a level surface away from heat sources.
Follow steps to adjust the refrigerator door for proper alignment and closure.
Control dial has 7 settings plus off. Set to 4 initially and wait 24 hours.
Instructions for removing, replacing, and reversing slide-out shelves.
Defrost freezer section when frost is 1/4" thick. Remove food, use drip tray, turn off thermostat.
Sounds like boiling water, gurgling, vibrations, and thermostat clicks are normal.
Prepare a baking soda solution for cleaning. Rinse with warm water and dry. Avoid harsh chemicals.
Clean gaskets every three months and apply petroleum jelly to keep them pliable and sealed.
Unplug during outages. Inspect and discard spoiled food. Clean before reusing.
Empty, turn to OFF, clean, and prop doors open. Move unit vertically.
Check thermostat, plug connection, and circuit breaker for power issues.
Check door openings, allow time for food to cool, check gaskets, adjust temperature.
Adjust temperature control to a warmer setting and allow time for adjustment.
Check normal operation, door openings, gasket seal, and door closure.
Note normal humidity, door openings, and check door gaskets for proper seal.
Clean interior and ensure foods are properly wrapped or sealed.
Level refrigerator, re-align door, and check for blockages.
General| Brand | Rvision |
|---|---|
| Model | RCR3910 |
| Category | Refrigerator |
| Language | English |
To Next Page