2-System safety
Please read the safety instructions carefully. For safety’s sake, please be aware
of the following:
Correct connection cables
Make sure all connection cables are safely and securely connected to the
equipment.
Avoidance of all exposed electronic cables
Do not touch any electronics and wiring inside the equipment!
Shutdown due to suspected failure
In the case of equipment safety hazard or failure of normal operation,
please contact the authorized technical support personnel.
Correct connection of equipment
Connect the equipment correctly to avoid operation difficulty or even
disconnection of equipment due to incorrect connection.
2.1 Safety symbols
The following safety symbols and general marks may be used in the User
Manual and on the equipment. If you have any question or suggestion regarding
safety, please contact RWD for after-sales support. To prevent damages to the
equipment and extend the service life of the equipment, please follow these
instructions carefully.
- General safety warning.
Operate the device only in accordance with this user manual. Follow
these general precautions during operation.
- High temperature warning.
Hot surfaces can burn unprotected skin or heat can damage materials.
- Risk of electric shock.
To avoid electric shock, the device must be properly connected to the
protective ground wire.
- Waste treatment. Separate taking back of electrical and electronic
instruments in countries of the European Union: this is applicable in
countries of the European Union and other European countries with a
To Next Page
Loading...