TECHNICAL DATA
ELT-3725 ELT-4235
Power supply 230 V ~ 50 Hz
Power consumption 370 W 420 W
No load speed 11,000/min 9,000/min
Safety class II
Cutting width 250 mm 350 mm
Line diameter 1.4 mm
NOISE EMISSION / VIBRATION
Values in accordance with EN
Noise level L: 83 dB (A)
Noise intensity L: 96 dB (A)
Vibration aw: 2.4 m/s
2
USER MANUAL & SAFETY GUIDE
Parts list:
■ Motor body with adjustable shaft
■ Handle with ON/OFF switch
■ Second handle
■ Line guard
■ Guide roller
■ 2 line spools
DESCRIPTION
1. ON/OFF safety switch
2. Cable restraint
3. Motor body
4. Push-button
5. Clamp
6. Second handle
7. Cut-out
8. Shaft
9. Line guard
10. Spool holder
11. Guide roller (For ELT-4235 only)
12. Handle
13. Line outlet
14. Pan screw
15. Line
16. Spool cover
17. Lock
18. Pump button
19. Line spool
21. Line cutter
22. Spring steel (For ELT-3725 only)
USAGE
Grass cutting around the home, in awkward locations,
against walls, along gutters and fences, small grassed
areas. Use only original accessories – follow
manufacturer’s instructions. Do not use for any other
purpose.
SAFETY GUIDE
■ When using your trimmer, wear sturdy shoes, long
trousers, eye protection and work gloves.
■ Never use your trimmer without the line guard.
■ Only people above the age of 16 should use the
trimmer.
■ To avoid injury from flying debris, maintain a distance
of at least 5 meters from other people.
■ Before you start work, check the body and cutting
head for damage. Do not operate damaged units.
■ Ensure the line spool is firmly attached in the trimmer.
■ Use your trimmer in an upright position, switching it
on before the line makes contact with the grass.
■ Always use the guide roller. Avoid contact with
stonework and rocks.
■ Always hold your trimmer with both hands.
■ Do not touch the spinning line.
■ Do not attempt to stop the cutting unit by hand.
■ Always keep the extension lead well clear of the
trimmer.
■ Follow general safety procedures for working with
electric tools.
INSTALLING THE SAFETY GUARD
Slip the guard over the spool holder until the two lugs clip
into the holder on the motor body. Tighten the four
locating bolts.
5
GB
F D E
English
I P NL S DK N FIN GR H CZ RUS RO PL
To Next Page
Loading...
