Ryobi ONE+ P922 - User Manual

To Next Page

TOOL LANYARD

P922

The lanyard snaps into the battery compartment of

most RYOBI

™

ONE+

™

18 volt portable hand-held

tools and provides a convenient method of storage

and transportation, as shown in Figures 1 and 2.

CAUTION:

Remove any blades, bits, or other sharp ob-

jects from the tool before attempting to store

or carry with the plug-in lanyard. Do not use

the lanyard with larger tools such as miter

saws. Use the lanyard only in RYOBI

™

ONE+

™

brand tools. Do not exceed maximum holding

weight of 10 lbs.

Fig. 1

Fig. 2

Fig. 3

ONE WORLD TECHNOLOGIES, INC.

1428 Pearman Dairy Road, Anderson, SC 29625 • Phone 1-800-525-2579

États-Unis, Téléphone 1-800-525-2579 • USA, Teléfono 1-800-525-2579

www.ryobitools.com

995000309

7-18-17 (REV:02)

A - Battery compartment

B - Lanyard stem

C - Latches

Always mention the model number when

communicating with us regarding this product.

INSTALLING/REMOVING THE

LANYARD

See Figure 3.

To install:

n Remove the battery pack from the tool.

n Insert the lanyard stem into the tool’s battery

compartment and press until the latches snap

into place.

To remove:

n Depress the latches on both sides of the lanyard

to release it from the tool.

Need help?

Do you have a question about the Ryobi ONE+ P922 and is the answer not in the manual?

Summary

Tool Lanyard Installation and Removal

How to Install the Tool Lanyard

Insert lanyard stem into the tool's battery compartment and press until latches snap into place.

How to Remove the Tool Lanyard

Depress the latches on both sides of the lanyard to release it from the tool.

Important Safety Precautions

Remove sharp objects, use only with RYOBI ONE+ tools, and do not exceed 10 lbs weight limit.