Safety
4
selected frequency is displayed on the LCD.
To tune frequency manually:
Briefly push either
or (not press and hold) to tune one
frequency step at a time.
1. Press and release
to tune to a lower frequency.
2. Press and release
to tune to a higher frequency.
To tune frequency automatically:
1. Press and hold
or to tune frequency automatically.
2. Press
or to stop scanning and select a frequency.
To decrease interference or electrical noise, adjust the
position of the antenna or move the product to a higher
elevation.
STORING A PRESET IN MEMORY
See page 12.
The memory feature saves up to 20 frequencies as presets
in the product’s memory. You can save up to 10 frequencies
each for FM and AM modes.
Tune to the desired FM or AM frequency.
1. Press and hold
until “MEMORY” and the preset
position number flash on the screen.
2. Press
and to choose a preset position number.
NOTE: There are 10 preset positions for FM and 10
for AM. Only one station can be saved in each preset
position.
3. Press
again to store the frequency.
To tune to presets (fm or am mode):
Ŷ Press and release
to cycle through each preset
position number and its associated frequency.
EQUALIZER FUNCTION
To adjust the bass and/or treble settings:
1. Press and hold
until “b” (BASS) is displayed.
Press again and “t” (TREBLE) is displayed.
2. Press
or until the desired bass or treble level (–5
to 5) is achieved . Press
to store your selection.
SETTING THE CLOCK
See page 13.
1. Press and hold
until the hour time blinks.
2. Press
or to select the hour.
NOTE: Time is displayed in 12-hour format only. To
select an hour that is afternoon and before midnight,
cycle the hours until “PM” appears in the display.
3. Press and release
to lock in the hour setting. Minute
time blinks.
4. Press
or to select the desired minute.
5. Press and release
again to confirm the time.
USING A PHONE/MP3 PLAYER (NOT INCLUDED) WITH
THE PRODUCT
See page 14.
NOTE: The retainer strap may be used to secure the
device into position.
1. Press
until AUX mode is highlighted.
2. Connect auxiliary cable (not included) to the device.
NOTE:
– The phone/MP3 player must be on and in play
mode for sound to be heard through the speakers.
– All phone/MP3 player controls can be used normally
while connected to radio.
– Volume for any device connected through the
auxiliary cable can be adjusted using the volume
control for that device or by using
or of the
product.
– Turning the product off will not turn the phone/MP3
player off.
– The auxiliary cable does not provide charging
function.
3. For complete operating instructions for the connected
device, always refer to the manual that was included
with your device.
USING A BLUETOOTH
®
ENABLED DEVICE (NOT IN-
CLUDED) WITH THE PRODUCT
See page 15.
1. Press
until the BLUETOOTH
®
mode is highlighted.
NOTE:
– When the product is switched to BLUETOOTH
®
mode, the product will attempt to pair to a
BLUETOOTH
®
enabled device and “bt” will flash in
the LCD display.
– The product will automatically attempt to connect
to the last device it was paired to. If a connection
cannot be established within five seconds,
the product will make itself available to other
To Next Page
