Ryobi RACWDV30MC2 - Troubleshooting

TROUBLE SHOOTING
WARNING
Problem Cause Solution
The appliance doesn’t work
No power
Check the power supply.
Check Overload Protection switch.
Check if switch is in position II without
appliance plugged in
Have the damaged part checked by
qualified personnel or replace it.
Empty the tank
Functional fault in the power cord, switch,
or motor
Tank is full of liquid
Dust is blowing out of the
motor air vent
The dust bag is missing or damaged Put in a dust bag o
Filters are or not correctly assembled Use missing filters or check the
correct position of the filter
r replace it.
Low suction power and high
motor speed / vibrations
Dust bag is full
R
Air control on the air regulator handle
is open
Close the air control
HEPA cartidge filter is full or clogged
Follow self cleaning procedure;
Clean or replace the filter
eplace the dust bag
Check the suction nozzle, hose, and
tank inlet for obstructions.
Suction nozzle, hose, or tank inlet is blocked.
To reduce the risk of personal injury, unplug the cleaner before performing maintenance/troubleshooting checks.
The air flow indicator is still
flashing red after completing
filter cleaning operation
Suction nozzle, hose, or tank inlet is
blocked.
Check the suction nozzle, hose, and
tank inlet for obstructions.
Remove and clean or replace with a
new filter.
Empty the container.
The cartridge filter has been contaminated
heavily.
The container is full.
16