12 — English
TROUBLESHOOTING
Problem Possible Cause Solution
Wax does not go on evenly. Too much wax on the bonnet. Remove a portion of the wax and retry.
Polishing seems difficult. Bonnet may be worn. Replace bonnet.
Polisher does not turn on. Bad connection to receptacle.
Problem with motor.
Check to make sure plug is properly
seated in outlet. If using an exten-
sion cord, check connection and wire
gauge.
Call authorized service center.
Pad spins slower than normal or not
at all.
Motor needs to be serviced or replaced. Call authorized service center.
To Next Page
Loading...
