Ryobi RIG2000PC - Page 45

34
English (Original instructions)
DRAINING THE FUEL TANK
CAUTION
Remove all lubricant from the product before draining
the fuel tank. Failure to do so could cause damage to
the product.
■ Remove the fuel cap.
■ Tilt the generator and allow fuel to drain from the fuel
tank into an approved container.
■ When the fuel has drained from the tank, replace the
fuel cap.
DRAINING THE CARBURETOR
■ Loosen the screws at the top of the engine cover.
Remove cover and set aside.
■ Place the engine/choke lever in the run position.
■ Position a suitable container under the carburetor
drain screw to catch fuel; loosen the screw.
■ Allow fuel to drain completely into container.
■ Retighten the carburetor drain screw securely.
■ Place the engine/choke lever in the off position.
NOTE: Consult hazardous waste management guidelines
in your area for the proper way to dispose of used fuel.
TRANSPORTING
■ Place the engine/choke lever in the off position.
■ Make sure engine and exhaust of product is cool.
■ Keep product level to prevent fuel spillage.
■ Do not drop or strike the product or place under heavy
objects.
STORING THE PRODUCT
When preparing to store the generator, allow the product
to cool down completely, then follow the guidelines on the
next page.