Ryobi RP4030 - Operation; Installing;Removing Battery Pack; Taking Temperature Readings

English
4
GB
FR DE ES IT NL PT DK SE FI NO RU PL CZ HU RO LV LT EE HR SI SK GR TR
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 2
To install the battery pack:
■ Unscrew the battery compartment cap.
NOTE: Do not remove the gasket inside the cap.
■ Insert the battery pack in the direction shown. Make sure the raised rib on the
battery pack aligns with the groove in the battery compartment.
■ Place the cap over the battery pack and push down until the cap meets the threads
at the end of the battery compartment.
■ Screw the cap on securely.
To remove the battery pack
■ Unscrew the cap. The battery pack will disconnect and be easy to remove.
■ Do not attempt to use this product if the battery cap is not securely closed.
TAKING TEMPERATURE READINGS
See Figure 3
For the most accurate readings, follow these hints:
NOTE: Temperature readings can only be measured on a target surface.
■ Place the unit less than 0.6m from the item you wish to read.
■ Accuracy of readings of 10C to 30C is +/- 1.5C of the actual temperature. All other
readings are +/- 1.5% of the actual temperature.
■ Readings at distances greater than 0.6m may be less accurate due to external
light sources, surrounding air temperature and reading of larger surface areas not
intended to be measured.
■ Cleaner surfaces will give more accurate readings.
To take a temperature reading:
■ Press and/or hold the trigger to scan the surface temperature of a target object.
■ The backlight and laser icon will come on.
■ The laser pointer indicates the center of the circular area being scanned for
reference only.
■ The surface temperature and maximum temperature readings are displayed.
■ When the trigger is released, the laser will turn off. The HOLD icon will stay on.
■ The backlight will turn itself off after a period of no use. Pressing any button will
turn the backlight on again when the LCD is still in use.
To take a maximum/minimum reading:
■ Hold the trigger to scan the surface temperature of a target object.
■ Move the laser beam from one target point to another desired target point while
holding the trigger.
■ Release the trigger. The maximum temperature is displayed. To display the
minimum reading, press the min/max button.
■ If desired, record the minimum/maximum reading.