What to do if Ryobi RPP720G Pole Saw motor runs, but chain is not rotating?
If the motor of your Ryobi Pole Saw runs but the chain doesn't rotate, the chain tension might be too tight, or there might be damage to the guide bar and chain assembly. Re-tension the chain. Inspect the guide bar and chain for damage.
Why is my Ryobi RPP720G bar and chain running hot and smoking?
If the bar and chain on your Ryobi Pole Saw are running hot and smoking, it could be due to the chain being too tight or the bar lube reservoir being empty. Make sure to tension the chain correctly. Also, check the bar lube reservoir and refill it if necessary.
Carefully remove the product and accessories from the box. Inspect for damage and keep packing material until satisfactory operation.
List of included items for the product. Verify all items are present before assembly.
Clean plastic parts with soft cloths, avoid solvents and petroleum-based products to prevent damage.
Procedure to check and adjust chain tension for safe cutting. Ensure chain is snug but turnable by hand.
Steps for removing and installing the guide bar and saw chain, including tensioning adjustments.
Instructions for filling the bar lube reservoir with premium lubricant for proper chain lubrication.
To Next Page
General
