18 — English
OPERATION
Reverse mode operation:
NOTICE:
The mower will emit a constant beeping sound when
operated in reverse with either the blade off or in reverse
mode operation.
Depress the brake pedal and bring the mower to a com-
plete stop.
Push blade engage knob down to turn blades off.
Place direction control switch in reverse (R) position.
Press the reverse mode button.
Raise the blade engage knob, slowly press accelerator
pedal, and reverse mow as needed.
WARNING:
Do not mow in reverse unless absolutely necessary.
Always look down and behind before and while back-
ing to make sure no children, bystanders, or pets enter
the mowing area. Be aware that the reverse mode
operation is activated when the reverse mode button is
illuminated in red and a constant beeping sound is emit-
ted. Remember that a careless fraction of a second is
sufficient to inflict death or serious injury.
WARNING:
Be especially careful before and when backing and turn-
ing around with the bagger kit installed, as it may limit
visibility. Always look closely behind and down for small
children, bystanders, and pets and move the mower
slowly to prevent back over accidents that can cause
death or serious personal injury.
When mowing is complete:
Stop mower on a flat, level surface. Do not stop the mower
on a slope.
Push the blade engage knob down to turn blades off.
Place the direction control switch in the neutral (N).
Set the parking brake.
Turn the start key OFF.
Remove the start key if leaving the mower unattended,
even if just for a brief period.
WARNING:
If the mower emits a beeping noise after you leave the
seat, verify that the parking brake is set and the key has
been removed. Failure to set the parking brake could
cause the mower to move, and leaving the key could
allow unauthorized use that could result in serious per-
sonal injury.
NOTE: Reverse mode operation resets each time the power
switch is turned to the OFF position.
MOWING TIPS
See Figure 12.
Keep mower blades sharp.
Make sure the lawn is clear of stones, sticks, wires, toys,
tree nuts, tree branches, and other objects that could
damage the lawn mower blades or motor. Do not mow
over property stakes or other metal posts. Such objects
could damage the blade or be accidentally thrown by the
mower in any direction and cause serious personal injury
to the operator and others.
For a healthy lawn, always cut off one-third or less of the
total length of the grass.
When mowing large areas, start by turning to the right so
that clippings will discharge away from shrubs, fences,
driveways, etc. After one or two rounds, mow in the op-
posite direction, making left hand turns until finished.
Mow so that discharged clippings exit in the direction of
the lawn area that has already been cut.
When cutting heavy grass, reduce speed to allow for more
effective cutting and a proper discharge of the clippings.
Do not cut wet grass. Mowing on wet surfaces can cause
loss of control, and wet grass will stick to the underside
of the deck and prevent proper bagging or mulching of
grass clippings.
New or thick grass may require a narrower cut or a higher
cutting height.
Keep the mower deck and side discharge chute clean.
Remove grass clippings, leaves, dirt, and any other ac-
cumulated debris before and after each use. Do not spray
with a garden hose to clean.
NOTE: Always stop mower, allow blades to completely
stop, and remove the start key before cleaning underneath
the mower.
Fig. 12
To Next Page
Loading...
