Runa harness delivered with pre-installed speedbar.
In case of need, you can install the speed system by yourself – before rst ight in the new harness or if replace of
speedbar needed.
It is convenient to install the speed system using a simulator — by hanging the harness on it.
Begin installing from front part of harness to back.
First, attach the speedbar to footplate by rubber lines.
INSTALLING SPEEDSYSTEM
ATTACHMENT TO THE WING
BEFORE YOU FLY
Before the rst ight, the harness must be prepared at home: install a reserve parachute, adjust the harness for the
pilot, adjust the accelerator. Harness adjustments can require serious attention, with many pilots adjusting the
new suspension after several ights to achieve maximum comfort and control. It is very important to understand
here that tting the harness is a long process, but the reward is high. We ask you to treat this section with all your
attention and do not hesitate to ask us questions directly.
If Runa is your rst cocoon harness, please note that landing in any cocoon, as well as piloting techniques, is quite
dierent from open harnesses.
To do this, install main carabiners in webbings on left and right sides of the harness – main hangpoints loop and
side adjustment straps. Locks of carabiners must be oriented forward in ight direction.
6
To Next Page