Need help?Do you have a question about the S.I.T.A. 400 Series and is the answer not in the manual?
Presents the recommended installation layout for the UV system.
Provides detailed steps for assembling the UV chamber.
How to set alarm values for temperature and irradiation levels.
Configures flow rate parameters for alarms and system readings.
Sets automatic start-up and shut-off times for the UV lamp.
Configures lamp post burn delay to ensure disinfection during startup.
Sets 4/20 mA output for chamber temperature and UV irradiance.
Schedules automatic cleaning cycles for the quartz sleeves.
Resets the lamp hour meter after lamp replacement.
Enables safe maintenance by disabling alarms and valve closures.
Calibrates the UV sensor to ensure accurate irradiance readings.
Allows manual control of the cleaning system direction.
General| Brand | S.I.T.A. |
|---|---|
| Model | 400 Series |
| Category | Cleaning Equipment |
| Language | English |
To Next Page