Receiver Function
The transmitter and receiver have finished binding by default. ，If it is a newly
bought receiver accessories, you need to refer to the following method of bind:
1.Put the transmitter and the receiver close to each other(about 60CM)；
2.Turn on both the transmitter and the receiver；
3.Press the button for more than 3 second and release, the LED will flash quickly,
indicating that the bingding is ongoing；
4.When the LED stops flashing and is always on, binding is complete . If not
successful, the LED will keep flashing slowly to notify, and repeat the above steps.
*Note: The close distance between the transmitter and receiver may cause a signal
block,which leads to unsuccessful binding or signal loss.After the binding is
successful,if the transmitter and receiver are too close,the signal may also be lost
because of signal block.Bring the transmitter and receiver father apart,the signal
loss will disappear automatically.
DDF-350 Basic Functions
Main
interface
General
menu
Model menu
General menu
Model menu
Transmitter settings
Language setting
Steering Curve
Throttle/Brake Curve
Rudder reading
Channel Phase
END Point
SUB Trim
AUX Channel
Key Type
Remapping
Model menu
Transmitter
settings
Gyro MIX
Tank MlX
Winch MlX
Program MlX1
Model Setting
Coaching Model
Timer
LED Mode
Sound Settings
Backlight
Power
Calibration
Factory Reset
- 16 -
To Next Page
Loading...