S.R.Smith FRONTIER II User Manual

1/2 METER
FRONTIER II
JUMP STAND W/JIG
STEEL STAND COMPLETE
6’ 68-209-586 8’ 68-209-588
CAUTION
ALL MINIMUM WATER ENVELOPE DIMENSIONS FOR RESIDENTIAL INGROUND SWIMMING
POOLS MUST MEET THE ANSI/NSPI-5 2003 AMERICAN NATIONAL STANDARD FOR
RESIDENTIAL INGROUND SWIMMING POOLS (REFERENCED THROUGHOUT THESE
ASSEMBLY AND INSTALLATION INSTRUCTIONS AS “ANSI/NSP-5 2003”). COMPLY WITH
LOCAL GOVERNMENT REGULATIONS IF THEY EXCEED ANSI/NSPI STANDARDS.
All diving boards and related equipment are manufactured for inground swimming pools ONLY. The
S.R. Smith Frontier II Jump Stands are designed to be easily transported and installed. Follow all
instructions carefully and inspect closely to assure proper and safe installation.
PROPER INSTALLATION CANNOT BE OVERSTATED. IMPROPER INSTALLATION VOIDS S.R.
SMITH’S WARRANTY AND MAY AFFECT THE SAFETY OF THE USER.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
– PLEASE READ CAREFULLY –
WESTERN SALES AND MANUFACTURING PLANT
CORPORATE HEADQUARTERS
P.O. Box 400 • 1017 S.W. Berg Parkway
Canby, Oregon 97013
Phone (503) 266-2231 • Fax (503) 266-4334
EASTERN MANUFACTURING PLANT
105 Challenger Drive
Portland, Tennessee 37148
Phone (615) 325-0770 • Fax (615) 325-0775
www.srsmith.com
ATTENTION!
THESE INSTRUCTIONS MUST REMAIN WITH STAND OWNER
06-305 AUG06

S.R.Smith FRONTIER II Specifications

General

Brand	S.R.Smith
Model	FRONTIER II
Category	Lighting Equipment
Language	English

Summary

Assembly and Installation Instructions

Important Safety Warning

Critical safety warning regarding proper installation and its impact on warranty and user safety.

Technical Specifications and Notices

Tightening Schedule

Specifies torque values for securing the board to the stand and the stand to the jig.

Anti-Seize Compound Usage

Mandatory use of anti-seize compound on stainless steel hardware to prevent galling and seizing.

Frontier II Jump Stand Installation Chart

Installation Steps

Step-by-step guide for setting up the jump stand jig and securing the board and stand.

Pool Water Envelope Requirements

General Requirements and Tolerances

Pool design dimensions must comply with ANSI/NSPI-5 2003 standards and construction tolerances.

Wall Requirements and Slopes

Details on allowable wall slopes and how they join the pool floor.

Water Envelope Dimensions and Slopes

Minimum Water Surface Shape

Defines the minimum water surface shape for diving areas.

Minimum Water Envelope Dimensions

Specifies width, length, and depth dimensions for the water envelope.

Pool Type Specifications and Features

Minimum Water Envelope Table

Table detailing minimum depths, widths, and lengths for various pool types.

Offset Ledges and Floor Slopes

Guidelines for offset ledges and floor slope compliance.

Diving Equipment and Pool Features

Manufactured Diving Equipment

Requirements for manufactured diving equipment installation and labeling.

Location of Equipment in Water Envelope

Specifies where diving equipment and other features must be located relative to the water envelope.