196 Car care
Dome light, rear
1 Remove the entire overhead panel:
ease out the trailing end first, and then
both sides of the front edge.
2 Fit the new bulb.
License plate lighting
1 Undo the two screws and remove the
lens.
2 Fit the new bulb.
3 Make sure the seal on the lens is
correctly seated.
4 Refit the lens and tighten the two
screws.
Glove compartment lighting
1 Remove the lamp housing using a short
screwdriver.
2 Fit the new bulb.
3 Fit the lamp fitting first and then insert
the connector.
To Next Page
Loading...
