234 Car care and technical information
Malfunctions
The above message is shown on the SID if:
• a wheel without pressure sensor has
been fitted (e.g. spare wheel)
• one or more pressure sensors are broken
or missing
• a fault has arisen in the receiver
• a system error has arisen.
Removing a tire
Remove the tire with a tire machine. It is
important to follow the instructions for the
tire machine as well.
•Do not fit the tire tool in an area ±10° from
the valve.
• Start removing opposite the valve.
• Remove the rear side first.
Fitting a tire
Fit the tire with a tire machine. It is important
to follow the instructions for the tire machine
as well.
• Start to fit about 20° after the valve.
• Finish fitting before an area 20° from the
valve.
•Do not inflate the tire to a pressure higher
than 102 psi (700 kPa).
Tire pressure system
failure. Contact service.
95_US_MY09.book Page 234 Tuesday, April 15, 2008 11:03 AM
To Next Page
Loading...
