Saab 9-5 - Page 85

85Instruments and controls
Adaptation of ACC
It is also possible to customize the ACC system, e.g. to adapt to
driving and weather conditions.
Adaptation and restoration of factory settings is done by holding
the respective button depressed approx. 2 seconds until a chime
sounds.
Make sure the ignition is ON.
Example: If you want the ACC system to handle activation and deac-
tivation of rear window/door mirror heating, hold the button
depressed approx. 2 seconds until a chime sounds.
The display shows:
ACC:AUTO
RDEFR CTRL
When “Adaptation of ACC“ is done, it will apply until factory settings
are restored.
Function Operation in AUTO mode
after adaptation
Factory setting
The rear window heating will
come on after the engine has
started if the outside temper-
ature is below +5 °C.
– This function helps to pre-
vent ice or mist forming on
the rear window in cold,
damp weather. Fuel con-
sumption may increase
slightly.
Heating is selected
manually.
Seat heating comes on if the
system determines that heat-
ing is necessary based on
the temperature in the seat
and the outside temperature.
There are two settings
for heating. Repeat-
edly pressing the but-
ton switches between
low output, high output
and off.
Function Display text in SID
during adaptation
Display text in SID when
factory settings are
restored
ACC:AUTO
RDEFR CTRL
ACC:MANUAL
RDEFR CTRL
ACC:AUTO
SEAT HEATIN G
ACC:MANUAL
SEAT HEATING
95_US_MY09.book Page 85 Tuesday, April 15, 2008 11:03 AM