B.
Accommodations and Safety
SEATS
The
backrest
and
cushion
of
the front seats
of
9005 and Turbo models have thermostat-con-
trolled
electric
heating elements
that
warm
up
automatically
when the
Ignition
Is switched on_
The
thermostat
ensures that the heaters are
switched
on
only
when the seat Is cold and sw
it
-
ched
off
when the temperature exceeds
82
°
F.
Both
front
seats are
adjustable
as to legroom,
and the driver's seat can also
be
adjusted
for
height. The
backrest
angle Is
continuously
ad-
justable
from
upright
to
reclining.
Legroom Adjustment
Release lever 1 (see
Illustration)
and slide
the
seat to the desired
position.
Backrest Angle Adjustment
The
backrest
angle can be
Infinitely
adjusted
between
driving
and resting
position
with
knob
3.
Moving the Backrest Forward
(3
,
Do
or
Models)
Move lever 2 and drop the backrest forward.
Vertical Adjustment
The
cushion
of
the driver's seat can
be
raised
and
lowered and also
tilted
to the front or rear.
As the
illustrat
ion shows, there are four possi-
ble
positions.
Adjustments
are made with handle 4 (see illus-
tration) at the forward edge of the seat. Release
the latch by pushing on the handle and moving
It
to the I
ntermediate
position
. The seat can
now be adjusted as
follows:
1.
Raised seat. Move the handle back
without
pressing down on the seat.
2.
Lowered seat. Move the handle forward,
pressing down on the
seat.
3.
Seat
tilted
back. Move
the
handle
back,
pressing down on the seat.
4.
Seat
tilted
forward. Move the handle forward
without
pressing down on the seat.
Headrest Cushions
9005 and Turbo models have removable rear
headrest
cushi
ons as
standard
equipment.
Rear
cushions
have a
mounting
post
which fits
into
a bracket attached to the
back
of
the rear
seat
backrest
, when so
equipped.
The rear
cushions
must
be pulled
out
when the seat is to
be
folded down.
Front seat head restraints have a vertical
ad-
justment
range
of
approximately
3
'1>
Inches.
To
raise, grasp both sides
of
the
cushion
and pull
upwards.
To
lower, press
down
on the top center
of
the cushion. A system
of
detents
will secure
the
cushion
at the desired
height.
®
To Next Page
