20
WIPER AND WASHER CONTROLS
The switch
controlling
the windshield wipers and wash-
ers has the
following
positions:
O.
Off position
1.
Windshield wipers,
low
speed
2.
Windshield wipers, full speed
3.
Windshield wipers, full speed. Windshield washers.
4.
Windshield washers
Starting from positions
0,
1
or
2 the windshield washers
are operated
for
as
long
as
the lever
is
held
towards the
steering
wheel in the spring
controlled
position. If the
lever is moved towards the steering wheel from the 0 pos-
ition, it is
possible to spray the windshield before the
wipers are switched on.
WIN
DS
HIELD WIPERS AND WASHERS
Inspect and clean the
rubber
blades
of
the windshield
wipers at regular intervals. If they show signs
of
wear,
they
should
be
replaced. Soap and water is recommended
f
or
cleaning.
Use clean fluid
for
the washer and make sure that the
container
is
free from dirt. Use suitable anti-freeze in
cold weather.
If the washer jets are blocked, the holes can be cleaned
and adjusted
with
a pin
or
similar
tool. If the jets are
out
of
alignment, the adjustable ball nozzles can be turned
to the desired position.
GEAR SELECTOR LEVER
Manual transmission
The gear positions are illustrated in the
diagram
below
.
To engage reverse, the catch on the gear lever must
be
pulled upwards first.
Automatic transmission
A scale beside the gear selector lever indicates
the
vanous positions by means
of
symbols.
P Park
D Dri
ve
R Reverse 2 2nd
gear>forward
N Neutral 1 1 st gear
The
lever can
be
shifted freely between the N and the 0
positions. The
other
positions are blocked by a catch
which is
released by depressing the button in
the
center
of
the selector knob. The lever can, however,
be
shifted
to D
or
N from positions
R,
2
or
1
without
pressing
down
the knob.
1 3
2
4 R
Gear p
os
itions.
manual transmission
Gear
selector lever.
automatic transmission
To Next Page
Loading...
