Need help?Do you have a question about the Saab L2.093LB and is the answer not in the manual?
Detailed explanation of numbered engine components shown in diagrams.
Specifications for fuel pump timing, injectors, and fuel quality.
Engine and gearbox oil capacities, coolant requirements, and system checks.
Explanation of the automatic excess fuel device and its function.
Details on the engine block heater, its voltage, and activation conditions.
Hurth gearbox types, ratios, and propeller rotation direction.
Procedures to follow before attempting to start the engine.
Detailed steps for starting the engine using the ignition switch.
How to engage gearbox, control speed, and safely stop the engine.
Safety warnings and general advice before starting any engine.
Essential checks to perform before engine ignition.
Specific steps for activating the emergency start system.
Step-by-step procedure for energizing and operating the spring starter.
How to operate the engine after spring start and how to stop it.
Warning against using glow plug with ether pump.
Critical checks and tightening procedures after initial operation.
Periodic maintenance checks and replacements based on time or hours.
Recommended ATF for gearbox and grease types for stern gland/remote controls.
Diagrams illustrating the correct order for tightening critical engine fasteners.
Procedure for checking engine oil level, noting installation angle effects.
Steps for changing engine oil and replacing the oil filter element.
Procedures for changing gearbox oil and fuel filter, and draining water separator.
Procedure for purging air from the fuel system after maintenance or running dry.
How to check and top up engine coolant level.
Procedure for safely draining the engine's coolant.
Procedure for checking thermostat function or replacing it.
How to adjust the engine's idling speed for optimal performance.
Note on hydraulic tappets meaning no valve clearance adjustment is needed.
How to check and adjust the tension of the alternator drive belt.
Procedure for inspecting, testing, and replacing the engine block heater.
Table showing specific gravity values related to temperature.
Formula and example for calculating specific gravity from voltage.
Guidelines for starting and running the engine while lifeboat is secured.
Crucial safety rules for working with the engine's electrical system.
Common causes and troubleshooting steps for difficult engine starting.
Causes and troubleshooting for excessive carbon buildup in the engine.
Troubleshooting common engine issues like stopping, power loss, and overheating.
Explanation of the stop/start lever and its interaction with the solenoid.
Visual representation of the stop solenoid electrical connections.
Information found on the engine's identification plate for ordering parts.
To Next Page
General