Need help?Do you have a question about the Saab R5 SUPREME MkII and is the answer not in the manual?
Requirements for qualified technicians and electrical safety.
Details the cables used for system installation.
Guidance on optimal placement of GNSS/DGNSS antennas.
Recommendations for GNSS antenna cabling to minimize signal loss.
Information on connecting the system to a power source.
Explanation of the buttons and LEDs on the R5 SUPREME CDU.
Guide to the initial system configuration wizard.
Views related to typical ship navigation tasks.
Lists and manages stored routes, including their waypoints and leg settings.
Initiates sailing from current position to a chosen destination waypoint.
Selects a waypoint and initiates sailing towards it.
Steps to create a new waypoint by entering name, latitude, and longitude.
Primary sources for support and RMA issues.
Provides functionalities for software upload, config management, and alarm logging.
Lists and describes all configurable parameters for the R5 Navigation System.
Configuration settings for the R5 DGNSS Navigation Sensor's beacon receiver.
Sets a reference point on the ship for horizontal measurements.
Changes the password for the R5 SUPREME CDU.
Configures alarms to be enabled or disabled, triggering outputs and popups.
Configures baud rates for input/output ports and speed log output.
Configures IP address and LWE ID for the CDU on the network.
Selects the R5 Navigation Sensor for communication on the LWE network.
Activates and configures the Redundant Navigation mode.
Specifies input port for depth sensor data and NMEA sentence configuration.
Configures input ports for NMEA messages, correction data, or alarm acknowledgement.
How to connect and configure slave CDUs to a master system.
Guide for upgrading the CDU software via USB or SD card.
Steps to load a CDU configuration file from a USB memory.
Steps to save the Sensor configuration file to a USB memory.
Steps to load a Sensor configuration file from a USB memory.
Using CDU LEDs to quickly verify system status.
Using alarm messages as aids for troubleshooting process.
Network setup for redundant navigation systems.
Interconnection setup for systems using slave displays.
Diagram showing a combined AIS and Navigation system configuration.
General| Brand | Saab |
|---|---|
| Model | R5 SUPREME MkII |
| Category | Car Navigation system |
| Language | English |
To Next Page
