SAAS Muscle Series Installation Instructions

Installation Instructions
DIGITAL COOLING FAN CONTROLLER
Page 1/4
Wiring Guide:
Wire colour
Wire Function
Wire Connection Location
Vehicle body
Battery 12V+
Ground 12V-
Black
Red
Ignition 12V+
Important notes before installing:
- Installing this product to your vehicle may require an adaptor. SAAS make a large range of
adaptors and installation parts, please check with your SAAS dealer for available adaptors.
- SAAS Muscle series gauges are designed for 12volt systems ONLY!
- All installation work should be done by a qualified professional to avoid damage to this product.
- SAAS RECOMMENDS all products be tested prior to installation. This will save time and speed up
the troubleshooting process if you encounter any issues.
Yellow
SAAS Automotive PTY LTD
25 Metrolink Circuit West Campbellfield
Victoria 3061 Australia
ABN: 48166279670 ACN: 166279670
Phone: +61 3 9930 0100
Fax: +61 3 8339 2270
Email: tech@saasautomotive.com.au
SINCE 1954
Blue
Ignition harness / Fuse box
Fan Controller Functions:
- Red wire must be connected to the (+) terminal of the vehicles battery.
- Blue wire connects to (+) side of fan/fans with a current draw no more than 35 AMPS!
- Black wire must be connected to a good grounding point, usually the vehicles body/chassis.
- Yellow wire must have 12V+ power when the ignition is in the ON position.
COOLING FAN CONTROLLER
SET
LIGHT
UP
DOWN
Up: This button is used to increase the temperature
preset.
Down: This button is used to decrease the temperature
preset.
Set: This button is used to set the temperature for controlling
your fan/fans.
Light: Press this button to change the back lighting
colour. (white>red>green>blue)
Fan 12V+ output
(+) terminal of battery
To fan/fans (+) side

SAAS Muscle Series Specifications

General

Brand	SAAS
Model	Muscle Series
Category	Automobile Accessories
Language	English