Before initial use
If you are using the kettle for the rst time, it is recommended
that you clean your kettle before use by boiling a full kettle of
water twice and then discarding the water�
Operation
1� To ll water into the kettle, remove it from the power base and
open the lid by press down the minimum (0�5L) and maximum
(1�7L) marks� Too little water will result in the kettle switching
o before the water has boiled�
NOTE: Do not ll the water over the maximum level, as
water may spill out of the spout when boiling. Ensure
that the lid is rmly in place before connecting the power
cord to the outlet.
2� Close the lid� Position the kettle on the power base in place�
Make sure the kettle contact with the power base completely�
3� Connect the plug into a power outlet� The six light under these
“press button” in the base will be on lasting 1-2 seconds, then to
be o�
If you only to boil the water, you can press the “ ” button,
then the “100°C”light and the “ ” light are on, the kettle will
begin to boil the water� You can press the any “press button”
anytime, such as “70°C”, “80°C”, “90°C”, “100°C” , the kettle will
boil the water to the designated temperature�
If you want to keep the water warm, you can press down the
“Keep warm” button and choose the designated temperature
button�
You can choose the “Keep warm” or not anytime�
NOTE: Ensure the lid is rmly closed. The kettle will spout
if the lid is left open.
4� Lift the kettle from the power base and then pour the water�
NOTE: Operate carefully when pouring the water from
your kettle as boiling water may result in scald, besides,
don’t open the lid while the water in the kettle is hot.
5� The kettle may be stored on the power base when not in use�
NOTE: Ensure power supply is turned o when kettle is
not in use.
Boil-dry protection
Should you accidentally allow the kettle to operate without
water, the boil-dry protection will automatically switch it o� If
this should occur, allow the kettle to cool before lling with cold
water and re-boiling�
2120
To Next Page
Loading...
General