ENERGY-SAVING TIPS
Install the fridge or freezer in a cool place out of direct sunlight
and away from cookers, heaters, dishwashers or any hot air
emitting items�
Do not set the fridge and freezer temperatures lower than
necessary� Set the internal temperature within the correct range
e�g� adjust the thermostat at middle position for 4°C in the fridge
compartment and -18°C in the freezer respectively�
Let pre-cooked foods cool down before placing them in the fridge
or freezer� This will prevent the internal temperature of the fridge
from rising�
Keep your fridge full, but not over crowded, this helps reduce
“cold”
air loss� Meanwhile, avoid overloading the fridge or
freezer� Try to leave about 20% free space for air circulation�
To prevent cold air escaping, limit the frequency of opening door�
When retuning from shopping, sort foods to be kept in your
fridge before opening the door� Only open the door to put food in
or take it out�
Make sure the door seal is clean and in good condition� It should
hold a piece of paper tightly in place when shut�
Defrost regularly or when ice is more than 5mm thick� Thick ice
covering the inner sides signicantly increases energy use�
The combination of the drawers, baskets and shelves shown in
the device description is optimal for ecient energy savings�
Changing the combination proposition could alter the eciency�
Handle Installation
1�
A� Take out the screw caps from the door handle holes�
B� Put the handles into the screw holes and then hit them to x �
2�
A� Cap the screw caps on the handle screws�
B� Take out the screw caps from the handle screw holes�
4544
To Next Page
Loading...
