2. After positioning the washer dryer
machine, press four corners on top cover of
washer dryer machine in sequence. If the
washing machine is not stable when being
pressed, this leg shall be adjusted.
3. Ensure the positioning status of washer dryer machine. Loosen
the lock nut with spanner and turn the leg with hand until it
closely contacts with the oor. Press the leg with one hand and
fasten the nut closely to the cabinet with the other hand.
4. After being locked properly, press four corners again to make
sure that they has been adjusted properly. If it is still unstable, it
has to repeat Steps 2 and 3.
5. Put a solid cylinder (e.g. pop cans) oppositely on the top cover
of the washer dryer machine from in the left, right, front and
back directions. If the cylinder keeps stable, the washer dryer
machine is positioned level. If it rolls, the washer dryer machine
is positioned unlevel. The rolling direction is the direction of
lower ground surface. Then, the two legs in this direction shall be
raised at the same time until the washer dryer machine is level.
Steps 1~3 are repeated to make the bottom legs closely against
the ground and the nuts shall be locked tightly.
Connect inlet pipe
Connect the inlet pipe as indicated in
the gure. For the model which has
hot valve, please connect the hot vale
to hot water tap. Energy will decrease
automatically for some program.
Remove transport bolts
Before using this washer dryer
machine, transport bolts must be
removed from the backside of this
machine. Please take the following
steps to remove the bolts:
1. Loosen all bolts with spanner and then remove them.
2. Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
Select the location
Before installing the washer dryer machine, the location
characterized as follows shall be selected:
– Rigid, dry, and level surface (if not level, please make it level
with reference to the following gure “Adjust Leg”)
– Avoid direct sunlight
– Sucient ventilation
– Room temperature is above 0°C
– Keep far away from the heat resources such as coal or gas.
Make sure that the washer dryer machine will not stand on
power cord.
Do not install the washing machine on the carpet oor.
Adjust Leg
1. When positioning the washer dryer machine, please rst check
if the legs are closely attached to the cabinet. If not, please
turn them to their original positions with hand or spanner and
tighten the nuts with spanner.
6160
To Next Page
Loading...
Need help?
General
