NOTE:
(*EN 60436)
This program is the test cycle. The information for com-
parability test in accordance with EN60436.
Turning On the Appliance
Starting a cycle wash
1. Draw out the lower and upper basket, load the dishes and
push them back. It is recommended to load the lower basket
rst, then the upper one (see the section entitled «Loading
the Dishwasher»).
2. Pour in the detergent (see the section entitled «Salt,
Detergent and Rinse Aid»).
3. Insert the plug into the socket. The power supply is 220-
240VAC150HZ, the specication of the socket is 10A 250VAC.
Make sure that the water supply is turned on to full pressure.
4. Press the program button, the wash program will be changed
as follows direction: lntensive->Universal->ECO->
90min->Rapid->Soak.
5. If a program is selected, the response light will light. Then
press the Start/Pause button, the dishwasher begins to start.
98
GB
To Next Page
Loading...
Need help?
General
