GB-18
connected to a properly installed earthed socket�
6� The mains voltage must correspond to the voltage specied
on the rating plate�
7� The socket must be installed and connecting cable must only
be replaced by a qualied electrician� If the plug is no longer
to accessible following installation, an all-pole disconnecting
device must be present on the installation side with a contact
gap of at least 3mm�
8� Adapters, multi-way strips and extension leads must not be
used� Overloading can result in a risk of re�
Installation Instructions
The accessible surface may be hot during operation�
Please Read the Manual Carefully Before Installation
Please note
Electrical connection
The oven is tted with a plug and must only be connected to a
properly installed earthed socket� The socket must only be installed
and the connecting cable must only be replaced by a qualied
electrician, and in accordance with the appropriate regulations�
If the plug is no longer accessible following installation, an all-pole
isolating switch must be present on the installation side with a
contact gap of at least 3 mm�
The tted cabinet must not have a back wall behind the appliance�
To Next Page
Loading...
