Need help?Do you have a question about the Sabaj A10H and is the answer not in the manual?
Install in a well-ventilated, cool, dry, and clean location, away from direct sunlight and heat.
Use only the specified voltage; incorrect voltage can cause fire and damage.
Do not attempt self-modification or repair; contact qualified service personnel.
Disconnect the power cable when the unit will not be used for extended periods.
7-day return/repair option, 1-year free warranty for normal use.
Purchase date is based on invoice or receipt.
Lists conditions not covered by warranty, such as human factors and unauthorized modifications.
Warranty service for mainland China is by sending the unit for repair.
Highlights ultra-low distortion (0.00006%) and output noise (1.3uV).
Features ultra-compact design, high-precision low-temperature drift resistance, and quality relays.
Includes Hi-End pre-out, popless sound, 256-level volume control, and wide frequency response.
Details output power (2W/1W) and 3-gear gain control.
Emphasizes comprehensive protection and an efficient low-noise power system.
Unit is equipped with a full-function remote control.
Specifies unbalanced inputs/outputs and detailed output power across impedances.
Lists SNR, output noise, THD+N, and THD values.
Details input/output impedance and frequency response range (20Hz-500kHz).
Covers gain settings, power supply, consumption, dimensions, and weight.
Guides on using the remote control, including aiming and potential interference.
Instructions for battery installation (AAA) and initial operation sequence.
Identifies front panel components: knob, headphone jack, remote window, and display.
Details rear panel connections: RCA input, RCA pre-output, and DC power input.
Advises turning down volume before connecting headphones and limiting listening time.
Explains the two pre-mode settings for signal path connection.
Describes the three selectable gain levels: Low, Middle, and High.
Outlines the three brightness levels available for the display.
General| Output Power (Speaker) | 80W x2(4Ω) |
|---|---|
| Input Impedance | 47kΩ |
| USB Chip | XMOS XU208 |
| Output Impedance (Headphone) | <1Ω |
| Input | USB |
| Output | 6.35mm headphone |
| Sampling Rate (USB) | Up to 32bit/768kHz |
| Output Power (Headphone) | 300mW@32Ω |
| Frequency Response | 20Hz-20kHz (±0.5dB) |
To Next Page
