To Next PageTo Next Page
Need help?Do you have a question about the Sabiana Energy SHP-130 and is the answer not in the manual?
General| Category | Fan |
|---|---|
| Airflow | 130 m³/h |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Model | SHP-130 |
Details user eligibility and safety precautions for unit operation.
Defines the intended use and purpose of the instruction manual.
Information regarding the unit's identification label and data.
Describes methods for unit installation (ceiling or wall) and general notes.
Provides specific guidance and steps for installing the unit.
Details the procedure for mounting the unit on a ceiling.
Details the procedure for mounting the unit on a wall.
Lists essential requirements for electrical connections and safety.
Overview of the unit's integrated display and its functions.
Steps for initial unit setup and verification after installation.
Explanation of how to navigate and use the main control menu.
Procedure for calibrating and setting fan airflow rates for optimal performance.
How to configure the filter replacement reminder interval.
Enabling and configuring the automatic ventilation mode based on conditions.
Configuring the unit's antifreeze protection logic.
Setting up the C1-C1 dry contact for external control.
Configuring the C3-C3 dry contact for specific functions.
Configuring the FC-FC dry contact for alarm or synchronization.
Configuring the unit's digital output signals.
Setting the serial port communication speed.
Assigning unique addresses for Modbus network units.
Instructions for wiring the T-EP remote control to the main unit.
Overview of the remote control's purpose and capabilities.
Description of elements displayed on the remote control's main screen.
Details the functions accessible via the technical menu on the remote.
Explanation of each button's function on the controller.
Interpretation of icons and messages indicating unit status or errors.
Visual representation of different operating modes and functions on the display.
Procedures for initial setup and verification of the unit.
Guide to adjusting fan speeds and airflow rates.
How to configure timed schedules for weekly operation.
Steps to create personalized weekly operating schedules.
Configuration of the antifreeze function via the SEE menu.
Configuration of the C1-C1 dry contact within the SEE menu.
Configuring the C3-C3 dry contact within the SEE menu.
Configuring the FC-FC dry contact within the SEE menu.
Configuration of the digital output signal for various functions.
Setting the data transmission speed for RS485 serial port.
Assigning unique addresses to units on a Modbus network.
Inhibiting specific functions from user access.
How the automatic mode operates based on ambient humidity.
Preventive logic for antifreeze without external heating.
Using electric preheating for antifreeze protection.
Details on Remote On/Off and Booster functions for C1-C1.
Details on Fireplace and Boiler functions for C3-C3.
Details on Alarm and Enabling signals for FC-FC.
Configuring digital output signals for various unit operations.
Configuration for post-treatment hydronic coil operation.
Configuration for pre-treatment hydronic coil with antifreeze.
How to activate and use the free-cooling mode for energy saving.
Basic steps for turning the heat recovery unit on and off.
Guide to navigating and selecting operational modes via the controller.
How to manually control ventilation speed and settings.
Explanation of the automatic mode's operation based on air quality.
How to activate the timed 'Party Mode' for intensive ventilation.
How to activate and configure the 'Holiday Mode' for anti-mould protection.
Steps to activate pre-set weekly operating programs.
Procedure for setting the unit's internal clock and day.
Instructions for activating the energy-saving free-cooling mode.
Instructions for replacing the unit's filters.
How to reset the filter life indicator via the integrated display.
How to reset the filter life indicator using the T-EP remote.
Procedure for inspecting and cleaning the heat exchanger.
Procedure for inspecting and cleaning the unit's fans.
Explanation of symbols and standard wiring configurations.
Wiring diagram for connecting an optional modulating electric resistance.
