Sabio CM1 - Connect to Wireless Access Point

a. Click on the “Setting” option on the left side
(gure-11).
b. Click on the “Client Scan Mode” photo below
the wording. The screen in gure-12 will ap
pear.
c. You will see a list of wireless access points
listed under the “Step 1” section of the
screen. If your wireless router or access
point is not listed, just click the “Refresh” link
on the page to have the CM1 rescan the
wireless signals at your location (gure-13).
d. NOTE: Initially the signal strength will be
high as the CM1 will be sitting next to
the router. If after conguration of the
CM1 you decide to move it to a different
location, the wireless signal of the router
or AP will change, and if it is below 50
the performance of the CM1 may be poor
or unacceptable.
You may want to reposition the CM1, the
antenna on the CM1, your router, or both, to
see if you can get a better signal. If you
cannot get the numbers to be close to 100,
you may want to use the CM1 in a wired
conguration to ensure optimal perfor-
mance.