EasyManua.ls Logo

Sabre WP-2020 - User Manual

Default Icon
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
WIRELESS HOME
PROTECTION SYSTEM
WHAT INCLUDED?
PAIRING THE TRANSMITTERS TO THE ALARM:
Pairing the alarm and transmitters:
1. Insert three AA batteries (not included) into the
Main Unit/Alarm.
2. Remove plastic battery insulation tab from the Key Fob.
Key Fob requires 1 CR2032 battery (included).
3. Remove plastic battery insulation tab from the Door/Window
Sensor. Door/Window Sensor requires 1 CR2032 battery
(included).
Paring the Transmitters:
4. Using a screwdriver, press and hold the Code button for 3
seconds on the Main Unit/Alarm. A single beep sounds.
5. Press any button on the Key Fob. A single beep sounds.
6. Separate the magnetic contact from the Door/Window sensors.
The red indicator light will turn on and the Main Unit/Alarm
beeps once to indicate the signal has been received.
Completing the Pairing:
7. Using a screwdriver, press and hold the Code button on the
Main Unit/Alarm again until the alarm sounds two beeps.
8. Release the screwdriver. Pairing is now complete. Repeat
these steps for additional transmitters (you can add up to
32 transmitters to the Main Unit/Alarm).
SEE ADDITIONAL CAUTIONS AND WARNINGS ON THE FRONT AND BACK OF PACKAGING.
3/11/24 | REV. V07
WARNING
INGESTION HAZARD
Contains coin or button battery.
Keep away from children.
WP-2020
Alarm Volume 125dB
Wireless Frequency 422.92MHz +/- 250KHz
Infrared Detection Distance ≤ 26ft (8m)
Infrared Alarm Angle ≤ 100°
Arm Mode Arming Delays 30s Each Time
Alarm Mode Alarm Once Triggered
Alarm Time 30s Each Time
Wireless Distance Up to 263ft (80m) (no barrier)
RECEIVER SPECIFICATIONS
Working Frequency 433.92MHz +/- 250KHz
Working Distance From
Main Unit/Alarm
Up to 98ft (30m) (no barrier)
TRANSMITTER SPECIFICATIONS: REMOTE KEY FOB
Working Frequency 433.92MHz +/- 250KHz
Working Distance From
Main Unit/Alarm
Up to 263ft (80m) (no barrier)
TRANSMITTER SPECIFICATIONS: DOOR/WINDOW MAGNETIC SENSOR
Main Unit/
Alarm
Key Fob
Door/Window
Magnetic Sensor
(Transmitter) x 2
Bracket x 1
Screw, Anchor
and 3M Sticker
Pack x1
4
5
6
7
1
2
3
Main Unit/
Alarm
Key Fob Door/Window
Magnetic Sensor
Main Unit/
Alarm
Key Fob Door/Window
Magnetic Sensor
Question and Answer IconNeed help?

Do you have a question about the Sabre WP-2020 and is the answer not in the manual?

Sabre WP-2020 Specifications

General IconGeneral
BrandSabre
ModelWP-2020
CategoryProtection Device
LanguageEnglish