EasyManua.ls Logo

Sabre WP-2020 - Page 2

Default Icon
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTALLATION:
Installing the Alarms:
1. Install the brackets to the desired mounting location using the wall anchor screws.
2. Place the Main Unit/Alarm into the bracket and adjust the angle of the Main Unit/Alarm by loosening the screw in the
bracket. Tighten the screws once the detection angle is set.
Installing the Door/Window Magnetic Sensors:
3. Make sure the arrows of both the magnetic strip and sensor on the
Door/Window Sensors are facing each other.
4. Install the Door/Window Sensors to a door or window using the
3M sticker.
The detecting range and angle of the PIR alarm
2m 4
m
6
m
8
m
60°
20°
100°
80°
OPERATION:
Using the System in AWAY Mode:
1. Slide the switch on the Key Fob up for AWAY mode and press ON.
2. The Main Unit/Alarm beeps once. After 30 seconds, the unit enters ARM mode.
The alarm sounds and flashes a light if:
The Door/Window installed with the magnetic sensor is opened.
Someone enters the property and the Main Unit/Alarm detects the intrusion.
3. To disarm the alarm, press OFF on the Key Fob. When the Main Unit/Alarm
receives the DISARM command, it will beep twice. If it is in the ALARM status,
the sound immediately turns off.
Using the System in HOME Mode:
1. In HOME mode, you are using the Door/Window magnetic sensors. The PIR
sensor in the Main Unit/Alarm is disabled in this mode but your windows and
doors are protected by the magnetic sensors while you are on the property. If a
door or window is opened, the alarm will sound. To disarm the alarm, press OFF
on the remote Key Fob.
2. Slide the switch down on the Key Fob to HOME and press ON. The Main
Unit/Alarm beeps once. After 30 seconds, the unit enters ARM mode.
3. To disarm the alarm, press OFF on the Key Fob.
Unpairing the Alarm:
To clear codes and unpair the Main Unit/Alarm from the receivers, ensure the batteries are removed and press and hold the
Code button on the Main Unit/Alarm at the same time as you insert the batteries. The alarm beeps twice to confirm that the
unpairing is successful.
AWAY
HOME
AWAY
HOME
SEE ADDITIONAL CAUTIONS AND WARNINGS ON THE FRONT AND BACK OF PACKAGING.
3/11/24 | REV. V07
1
2
3
Bracket with
Wall Anchor Screws
Main Unit/Alarm
Key Fob
Key Fob
Door/Window
Magnetic Sensor