Installation Methods
NOTE: Please first make pairing or reselect melody, then test whether the
operation ranges you choose is proper and prepare an electric drill or hammer,
cross screwdriver and slotted screwdriver if you prefer to fix transmitters by
screws.
Installation of Receiver:
Plug-in type: Just plug it into any outlet.
Battery-operated type: Make 2 holes on wall with screws and hammer or drill.
Then hang the receiver. Or just put receiver on table in room.
Installation of Transmitter:
Adhesive sticker
Please prepare clean cloth.
a. After ensuring the right operating range. Clean the place where to install the
sensor.
b. Tear off one side of the double-sided adhesive sticker and stick it to the
underside of transmitter; tear off the other side and put them onto door edge and
door frame and press for 10 seconds. Ensure there’s no gap between two parts.
Screw
You also can use screws in the package to fix two parts of door sensor onto the
door edge and doorframe separately.
______________________________ 5 _______________________________
To Previous Page
Loading...